Feiss MR1093 Mirror - Manual

Carefully unpack and identify all parts before assembly.
1. Assemble frame and glass mirror (see fig. 1):
A. Lay the frame, with screw holes side facing up, on a
non-abrasive surface.
B. Gently lay glass mirror, with metal support brackets side
facing up, on top of frame. Holes in support brackets must
align with holes in frame.
C. Secure brackets onto frame by fastening with enclosed
short screws.
2. Install mounting bracket onto wall (see fig. 2):
A. Hold assembled mirror on desired wall location and
lightly mark the location of upper support bracket, which is
located at rear of mirror. Place mounting bracket at proper
location on marked outline. Suggest using a leveler to make
certain the bracket is held at horizontal position. Mark onto
wall the two holes in the bracket.
B. Dry wall or Tile on Dry Wall Installation: Pre-drill holes
using 3/8" drill bit. (Tile on dry wall installation requires 3/8"
masonry drill bit).
Wood Wall Installation: Pre-drill holes using 1/8" drill bit.
Masonry Wall or Tile on Masonry Wall Installation: Pre drill
holes using 1/4" masonry drill bit.
C. Dry Wall or Tile on Dry Wall Installation: Insert machine
screws through two holes in mounting bracket. Thread
butterfly anchors into machine screws as shown in diagram
(fig. 2). Pinch together the ends of butterfly anchors and push
into predrilled 3/8" holes until anchors spring open inside of
wall. While pulling mounting bracket away from wall, tighten
screws with a screw driver.
NOTE: For more secure installation of the product onto a
dry wall, we recommend screwing directly onto vertical
wood stud/s or horizontal wood brace (horizontal plank in
between vertical studs) located behind the wall. Use an
electronic stud finder to locate stud or brace. If stud or
brace do not exist at desired location, then recommend
hiring a qualified contractor to install a wood brace behind
the wall.
Wood Wall Installation: Insert sheet metal screws through
two holes in mounting bracket. Fasten screws directly into
predrilled 1/8" holes.
Masonry or Tile on Masonry Wall Installation: Insert plastic
anchors into pre-drilled 1/4" holes. Insert sheet metal screws
through two holes in mounting bracket. Fasten screws into
plastic anchors.
3. Install the assembled mirror by hooking onto the installed
mounting bracket. Before hooking, note correct position of
support bracket in fig. 3.
Assembly Instructions For
MR1093
Mounting Bracket
Mounting
Bracket
Sheet Metal Screw
Machine Screws
Short Screws
Support
Bracket
(E) 10/08
Glass Mirror
Support
Bracket
Frame
Plastic
Anhor
Butterfly
Anhor
FIG. 2
FIG. 3
FIG. 1