GAM SX4 TS6200 User Manual

GAM Lighting

Advertising
background image

Page 1 of 1

GAM Product #TS6200

Rosco Product #206 36000 0000

PRODUCT INSTRUCTIONS

www.rosco.com

1. You will need one Phillips Screwdriver.

(Go get it. We’ll wait here).

2. Place your completely assembled ETC Source IV in

front of you. Using the Phillips screwdriver, remove the

Barrel Rotation Knob and the Retainer Bolt from the Barrel

Assembly. These two pieces are located roughly in the

middle of the instrument, on the top and bottom, just be-

tween the shutters and the yoke. Place the Barrel Rotation

Knob and the Retainer Bolt in a secure place that you’ll

remember. You will need them again in just a moment.

3. Rotate the Barrel so that it disengages and comes

away from the lamp housing. You should now have two

separate pieces. Completely unscrew the Beam Focus

Knob and remove it from the Barrel Assembly. Slide your

Lens Tube out of the Barrel and place the Barrel Focus

Knob inside the Lens Tube for safekeeping. Place your

now empty Barrel on a storage shelf and say goodbye

for now. You will not need it again until you are finished

using your SX4®.

4. Place your SX4®, Barrel side down, on the table.

Place the top of your ETC Source IV over the SX4® and

gently rotate until the two pieces engage. As you do this,

make sure you have it adjusted for the angle you wish to

project with our effect unit. (Either 90º or straight on, de-

pending on the loop design and/or your hang position)

SX4® case attaches here

(replaces barrel)

Retainer bolt

Barrel knob

Barrel

Remove Barrel

Lens Tube

5. Replace your Barrel Rotation Knob and your Retainer

Bolt into the appropriate fittings. If you are using the SX4®

unit in the standard, “straight on” position, you will find

it necessary to place the Retainer Bolt on the bottom of

the unit, where the Barrel Rotation Knob would normally

attach. This is because the fan housing on the SX4® and

the larger Barrel Rotation Knob impede each other.

6. Tighten down both bolts to secure the SX4® housing

into the Reflector Housing. Slide the Lens Tube into the Bar-

rel of the SX4® and secure it with the Beam Focus Knob.

(Told you not to misplace it!) Now your SX4® effect pro-

jector is ready to be placed in its hanging position.

7. When you have finished using the SX4®, it can be re-

moved from the Source IV Reflector Housing, and the Source

IV can be reassembled, using the above steps again.

SX4® INSTALLATION

Advertising