Behringer B-CONTROL NANO BCN44 - Manual (Page 13)

13
B-CONTROL NANO BCN44
5. SPECIFICATIONS
4.1 LEARN function
The easiest way to assign MIDI functions to individual control elements is to use the LEARN function in the
EDIT mode. Here, the assignment is done “from the outside.” For example, MIDI data that you are sending
from a MIDI sequencer to your B-CONTROL are assigned to a previously selected control element.
Using the LEARN function, in addition to receiving CC, NRPN and note commands, almost all types of MIDI
data can be received, including short SysEx strings.
s Keep the EDIT/EXIT button pressed and actuate the desired control element (push encoder or button).
The control element is shown in the display.
s Release the EDIT/EXIT button and press the LEARN button . The B-CONTROL is ready to receive
a MIDI command.
s Start the desired MIDI command on your sequencer or software synthesizer.
s After successful data transmission, “GOOd” is shown in the display; otherwise, “bAd” is shown in the
display if false, defective or excessively long data was sent.
s To leave or cancel the LEARN function, press the EDIT/EXIT button.
s Store your changes in a preset.
5. SPECIFICATIONS
CONTROL ELEMENTS
Controls 4 endless push encoders
Buttons 4 buttons
4 system buttons
MIDI INTERFACE
Type 5-pole DIN connectors IN, OUT
DISPLAY
Type 4-digit 7-segment LED display
POWER SUPPLY
Voltage U.K./Australia 240 V~, 50 Hz
Europe 230 V~, 50 Hz
China 220 V~, 50 Hz
U.S.A./Canada 120 V~, 60 Hz
Japan 100 V~, 50 - 60 Hz
Mains connection external power supply, 9 VAC/250 mA
Battery operation 3 mignon batteries, type LR6 (AA)
DIMENSIONS/WEIGHT
Dimensions
(H x W x D) approx. 9 " x 2 3/4 " x 7 "
(230 mm x 70 mm x 180 mm)
Weight approx. 1 lbs. 4 oz.
0.6 kg (without external power supply)
BEHRINGER makes every effort to ensure the highest standards of quality. Necessary modifications are carried out without notice.
Thus, the specifications and design of the device may differ from the information given in this manual.