Gardman Cubist - Manual

A B
Contents
• Top section, bottom section, pump and transformer
Assembly Instructions
• Unpack all items and place on a flat surface
• Connect the rubber tube from the top section to the pump (A)
• Connect the lead from the LED in the top section to the extra lead running from the pump (A)
• Place the top section onto the base, placing the corner feet onto the four corners supports in
the base. Ensure that the pump sits in the base and the rubber tube is not kinked (B)
• Fill the feature with water to within 50mm of the top of the base
• Connect the long lead from the pump to the transformer (B)
• Insert the plug from the transformer in to the power socket and switch on. If installed correctly water
will start to flow from the feature. Please note: On first use, there may be air in the pump and it may
take a few moments for the water to come through
www.gardman.co.uk
Base section Top section
19189AT Cubist Outdoor Water Feature
Please read the assembly instructions and pump instructions carefully prior to installation.