GeoDesy FSO Pluto Mobility - Manual (Page 17)

GeoDesy Kft. Telefon: 06-1-481-2050
H-1116 Budapest, Kondorfa str. 6-8. Fax.: 06-1-481-2049
E-mail: [email protected]om
http://www.geodesy-fso.com
17
Horváth Holding
Investment PLC.
Link alignment
The sheet below is a quick overview table of how the alignment steps following each
other. Pluto is only 20 meter distance, however the installation, is still the same as
for the longer distance units. Only one head should be moved at the time. Moving
both units will make confusion and make the installation time longer.
Side A
Side B
1, Roughly align the links horizontal
alignment and tighten the Hand-knob
1, Roughly align the links horizontal
alignment and tighten the Hand-knob
2, Roughly align the vertical position and
tighten the vertical fixing bolts 2, Roughly align the vertical position
and tighten the vertical fixing bolts
3, Turn on device (1s long beeping) 3, Turn on device (1s long beeping)
4, Using the built in pointer, direct the laser
head to Site A pointer
5, Using the built in pointer, direct the
laser head to Site A pointer
6, check receiving level you should be able
to see 1-3 LEDs after the alignment
depending on the distance 6, check receiving level you should be
able to see 1-3 LEDs after the
alignment depending on the distance
7, tighten the horizontal and the vertical
fixing.
7, tighten the horizontal and the
vertical fixing.
During the alignment the receiving levels will show you the reception from the
remote end. Also it is an indication of the laser head settings on your local end as
well. The receiver lens focuses the beam into the receiver so if your head is pointing
some other direction, you wont have receive even if the remote ends head is point at
your end.
The unit turns off the beeping after the receiving level is not changing. 30 seconds
later the Laser pointer will turn off as well you can always turn them on by blocking
one of the heads, transmitter and receiver as well.