Apa panel roof diaphragms – Georgia-Pacific APA Engineered Wood Construction Guide - Roofs User Manual

Page 11

Advertising
background image

ENGINEERED WOOD CONSTRUCTION GUIDE

FORM NO. E30V

© 2011 APA – THE ENGINEERED WOOD ASSOCIATION

WWW.APAWOOD.ORG

68

Roof Construction

APA Panel Roof Diaphragms

With only slight design modifications, any APA panel roof deck system described in the previous sections will also
function as an engineered diaphragm to resist high wind and seismic loading. A diaphragm’s ability to function effec-
tively as a beam, transferring lateral loads to shear walls, is related to the quality of the connections. Nailing is critical
since shear loads are trans mitted through these fasteners. Common nails provide required strength. Other nail types
may be used when their lateral bearing values are considered in the design. Load-carrying capacity is highest when the
diaphragm is blocked.

Where Performance Category 1-1/8 roof panels are desired, such as for Heavy Timber construction (

see page 75)

, shear

values for Performance Category 19/32 panels are used. Blocked shear values for Performance Category 1-1/8 panels
may be obtained by specifying stapled tongue-and-groove edges. Staples shall be 16 gauge, 1 inch long with a 3/8-inch
crown, driven through the tongue-and-groove edges 3/8 inch from the joint so as to penetrate the tongue with both legs
of the staple. Staples shall be spaced at one-half of the diaphragm boundary nail spacing for Cases 1 and 2, and at one-
third the diaphragm boundary nail spacing for Case 3 through 6, as illustrated in

Table 38

.

Table 38 gives panel and fastening recom men dations for roof diaphragms. Panels and framing are assumed already
designed for perpendicular loads. To design a diaphragm, follow these steps:

1. Determine lateral loads and resulting shears.

2. Determine nailing schedule (

Table 38

). Consider load direction with respect to joints.

3. Compute chord stress due to bending moment.
Provide adequate splices. Check deflection. Check
anchorage of boundary framing (e.g., chords) to walls.

For information about developing higher dia-
phragm shears than shown in

Table 38

, see

APA

Design/Construction Guide: Diaphragms and Shear Walls,
Form L350

.

FIGURE 25
OPEN SOFFIT

Shim at each rafter for flush joint, if necessary,

at change of panel thickness

APA RATED

SHEATHING

or any appropriate

APA Exterior or Exposure 1

panel grade and thickness for

desired appearance and

load-carrying capacity

(see Tables 30 and 36)

Strength axis

Protect edges of

Exposure 1

sheathing

against

weather

FIGURE 26
CLOSED SOFFIT

Protect edges of

Exposure 1

sheathing

against

weather

Any appropriate

grade of Exterior panels

for soffit (see Table 36)

Continuous

screened vent

or louvered vent

Leave 1/8" space at all panel end and edge joints.

Support all panel edges.

APA RATED SHEATHING

Strength axis

Advertising