HMC Electronics EDU2AE Kolver Programmable Power Control Unit for PLUTO Electric Torque Screwdrivers User Manual
Page 2
EDU1AE/TOP and PLUTO deliver all the advantages of precision torque control electric tools at a fraction
of the price of transducerized tools.
The state-of-the-art electronic control circuit cuts the power supply to the motor calculating the correct
torque in response to 3 parameters; voltage, frequency and current, according to the selected options.
IMPORTANT: EDU1AE/TOP controller is a highly accurate unit but it is critically important to
select the correct options to ensure that proper torque is being applied. Read the menu description
carefully and in case you are unsure please contact Kolver for support information.
Here are a few advantages of EDU1AE/TOP:
•
One controller only for a torque range from 2 to 15 Nm. For lower torque values, we offer the
EDU1AE/LTP/TOP.
•
User interface screens: walk through a few simple steps to input the parameters requested for your
application and your fastening process can begin.
•
8 independent programs: with one PLUTO screwdriver you can replace 8 conventional
screwdrivers.
•
Each program can accept the following settings: Torque, Speed, Type of Joint, Number of Screws
to be tightened, Number of Rejects allowed, Minimum screwing time, Maximum screwing time,
Ramp time, Auto reverse, Auto switch to the next program with any sequence, Allow or Prevent
reverse option.
•
Password protected.
•
Statistics menu with summary of work done: at the end of the day you'll know how many cycles
have been performed correctly, how many wrongly, total number of screws etc.
•
15 input and 11 output connectors: you can control all functions from PLC.
•
Options include Socket tray or Switch box: maximum flexibility. USB port.
•
Large 135 x 40mm blue display: easy to read from any angle.
Turn the unit on through the on/off switch on the back panel. The unit will perform a general system check
then will show the first screen. Push MENU button for 1 second and display the main screen indicating the
Program (1 to 8), the Torque Level, the Joint type (Hard or Soft), the Screws Done and Set and the Rejected
Screws.
The five upper fields indicate the setting
of the unit.
PR_ cycle:
it indicates the Program you are in, it goes from 1 to 8 or EXT.
% Torque:
it indicates the pre-set torque as a percentage.
Soft/Hard Joint:
it indicates the pre-set joint.
Screws Done/Set:
it indicates the screws done on the pre-set screws.
Reject:
it indicates the rejected screws.
The five lower fields represent:
PR1
4%
Soft
0/5
0/1
Cycle
Torque
Joint
Done/Set
Reject
SCREWS
ScrOK
ScrNOK
CycleOK CycleNOK
END
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440