HYDAC CMWIN - Manual (Page 26)

CMWIN ENGLISH Page 26
Edition 06/2007
3.7.7 Print
• To print a recording, click on the “File“ dialogue box and select “Print“ in the dropdown
menu, or click on “Print“ at the bottom left of the window.
• The “Print“ window opens.
• In the upper part you can choose whether you want to print the recording in black & white
only (“Monochrome“).
• In the lower section you can decide which portions of the recording are to be contained in
the printout by clicking on the checkbox before the particular portion.
• Click on “Print“ at the bottom of the window.
• Click on “Cancel“ to cancel the action.
3.7.8 Close
• To close the measurement curve you are currently editing, click on the “File“ dialogue
box and select “Close“ in the dropdown menu, or click on “Close“ at the bottom left of
the window.
3.7.9 Close All
• To close all open measurement curves, click on the “File“ dialogue box and select
“Close all“ in the dropdown menu, or click on “Close all“ at the bottom left of the
window.
• If you have not saved your recordings, you are prompted to do so.
3.8 Managing sensor configuration of the SMART sensors in CMWIN
3.8.1 Managing the sensor configuration (only if supported by sensor)
Using CMWIN you can read out the actual configuration from the SMART sensor connected
to the HMG in the pass-through mode, add comments to it or transfer a configuration stored
on your PC to the SMART sensor.
• Click on the “SMART sensors“ dialogue box.
• “SMART sensor“ opens in a new window.
• Establish a link to the SMART sensor and switch on the pass-through mode, as
described in 2.6 Establishing a link with the SMART sensor or 2.6.2.
• After establishing the link, select "Manage sensor configuration“ on the left of the
window.
• On the right of the window "Manage sensor configuration" appears.
• In the dropdown menu, select the required group element and insert your comments, if
required.
• Click on "Read out from sensor", to store the actual sensor configuration in your PC.
• Click on "Transfer to sensor", to transfer a configuration stored on your PC to the
sensor and therefore to re-configure the sensor.