Hydro-Logic Ecospring - Manual (Page 9)

9
370 Encinal Street, Suite 150
Santa Cruz, Ca 9506
0
P: 888-426-5644 / F: 831-336-9840
www.
hydrologicsystems.com
Cartridge Replacement
1.
Close the feed water shut-off valve.
2. Close the tank shut-off valve.
3. Open the dispensing faucet to relieve system pressure. Close dispensing faucet when fl ow has stopped.
4. Remove the cover from the front of the system. Remove the retaining clip. Pull the cartridge off the system evenly at
top and bott om. Dispose of used cartridge.
6. Install the new cartridge, rocking gently from side to side as necessary unti l the cartridge tubes are properly engaged in
the unit connectors. Install the retaining clip, ensuring the slide locks snap into place in the slots. If the clip does not snap
easily into place through the slots it means the cartridge is not fully inserted into the connectors. Press the top or bott om of
the cartridge to engage the connector so that it snaps fully into place. Failure to properly install the retaining clip will result
in accidental leaks and fl ooding.
7. Turn on feed water shut-off valve and open dispensing faucet.
8. Close dispensing faucet aft er water starts running.
9. Observe system for any leaks, especially at newly re placed cartridge.
10. Open the tank shut-off valve.
11. The system should be fl ushed at least once as described above under Secti on 8.
Post Filter Replacement
1.
Close the feed water shut-off valve.
2. Close the tank shut-off valve.
3. Open the dispensing faucet.
4. Close the dispensing faucet when the water stops fl owing.
5. Locate the inline fi lter on the faucet line.
6. Remove the tubing by depressing the collet in a downward directi on and pulling the blue tubing from the fi lter.
7. Remove the other side of the feed tubing as described above.
8. Reverse the above steps to install the new inline fi lter, making sure that the tubing is pressed in as far as possible.
9. Turn on the feed water valve. Observe system for any leaks, especially at newly re placed cartridge.
10. Open the tank shut-off valve.
11. The system should be fl ushed at least once as described in System Acti vati on and Flushing.
Maintenance