iCreation i-800 - Manual (Page 5)

Chapter 2: Bluetooth and Remote Control
Pairing with an iPhone
Connecting an iPhone
Disconnecting an iPhone
Removing a Paired iPhone
Remote Control for Music
20
20
22
23
24
Contents
Chapter 1: Getting Started
Features List
Phone Layout
Key Functions
Handset Screen
Package Contents
Connecting
Installing the Battery
Charging
Turning On or Off the Phone
Registering a New Handset
Deactivating a Handset
Choosing the Dialing Mode
Setting Date & Time
Chapter 3: Basic Functions
Making a Call
Receiving a Call
Using the Speakerphone
Adjusting the Volume
Muting a Call
7
9
10
26
12
28
13
29
14
29
14
29
15
16
16
17
18
18
4
Symptom Solution
The p hone doesn't work
properly with some special
services or if it is connected
to an exchange extension
(PABX).
The h andset can only
receive calls. The keypad
locked.
The b attery charge level is
very low.
Logical malfunctioning in
the handset or base unit.
Disable Bluetooth in the
iPhone and then enable it
again, the disconnected
Bluetooth connection
between the base and the
iPhone cannot be
automatically resumed.
If there are interference
signals near or iPhone was
taken away from the base
(longer than 10 meters)
ever, the phone may lose
the connection with iPhone.
Press and hold .
Check the Flash time and set it
properly.
Clean the charging pins, and if
the problem is still not solved,
replace the batteries.
Try resetting the handset or the
base.
Due to differences in each
iPhone's software, so it is normal
for some iPhone that the
Bluetooth connection cannot be
automatically resumed. If in this
case, please establish the
Bluetooth connection manually
(See P20~ P21 "Connecting an
iPhone").
Switch off Bluetooth feature on
iPhone, then switch it on again.
/ Power off the base and then
power on.
61