iCreation i-800 - Manual (Page 6)

Last Number Redial
Flash Signal
Using a Pause
Out of Range Indicator
Locking the Keypad
Paging
Temporary Tone-Dial Switchover
Intercom
Transferring Calls between Handsets
Three-way Conference Calling
Chapter 4: Display and Sound
Brightness
Wallpaper
Handset Name
Ring Setting
Key Tone
Power Off Tone
Charging Tone
Chapter 5: Call Logs
Incoming Calls
Dialed Calls List
Chapter 6: Contacts
Storing Contact Entries
Character Map
Reviewing or Dialing a Number in Contacts
Speed Dial
33
33
34
35
43
35
44
45
36
46
37
38
38
39
40
42
30
30
30
31
31
32
32
5 60
Chapter 10: Additional Information
Troubleshooting
Symptom Solution
The handset doesn't
turn on.
The h andset works, but
it doesn't access the
base unit.
The h andset works and
it accesses the base unit,
but no dial tone is
The h andset works
perfectly, but a beep
occurs during phone
calls.
There is n oise and audio
interference during
phone calls.
Try charging the handset for a few
minutes, then remove it from the
base. If it still doesn't turn on, check
the battery installation.
If these efforts are unsuccessful, try
replacing the batteries.
Contact an authorized service
center.
Check the connection of the
switching power supply.
Check the connection of the phone
line cord.
Check the batteries charge and
charge them if necessary.
Get closer to the base unit. If you
can access more base units, try
selecting a closer one.
Try registering the handset to the
base.
The h andset works
perfectly, but it doesn't
ring with incoming calls.
Select another ring level.