INCRA Wonder Fence User Manual
Page 6
6
Fig. 11
Vertical panel
raising
Adjust infeed/outfeed fences to
the in-line/mid-range position as
described on page 4 .
Use a straightedge to adjust the
Hi-Rise fence cap in line with the
infeed and outfeed fences . (See
page 10)
Remember: Do not make the full
width of the cut in a single pass .
Instead, use several light side-
by-side passes, moving the fence back
1
⁄
16
" or so after each pass .
In-line Fence applications
Once set to the in-line/mid-range
position as described on page 4, your
new INCRA Wonder Fence can be
used for a variety of typical in-line
fence applications, including grooving,
dadoing, and edge forming operations
such as rabbeting, chamfering, and
roundovers . You’ll also find the in-
line position useful for many specialty
operations . With the Hi-Rise fence
cap, you’ll be able to use vertical panel
raising bits to make raised panels
for cabinetry, and since its design
is compatible with all INCRA joint-
making accessories, you’ll be able to
use the Wonder Fence in conjunction
with your INCRA Jig Ultra as a joint-
making fence .
The introduction of the vertical panel
raising bit has made cutting the reveal
on a raised panel a relatively simple
operation for the router table . You’ll find
your new Wonder Fence, with its built-in
dust collection, adjustable fence gap,
and Hi-Rise fence cap, perfect for this
operation . The setup is as follows:
Fig. 11:
Install vertical panel raising bit and
set appropriate depth of cut .
Adjust fence gap as necessary
(see Gap Adjustment on page 5) .
❒
Whenever using large diameter
vertical or horizontal panel
raising bits or any other large
diameter bit, always follow
that router bit manufacturer’s
operation and safety
recommendations .
❒
Whenever it is necessary to
remove large amounts of
stock, always use multiple
side-by-side passes to achieve
the final cut . Several shallow
cuts are safer and will yield
better results .
safety
Adding an INCRA Jig Ultra to your Wonder
Fence makes precise placement of multiple
side-by-side cuts a cinch . One such
operation requiring this kind of precision
is joint making . Once placed in the in-
line/mid-range position, your new Wonder
Fence becomes a perfect replacement
for the standard straight fence commonly
used with the INCRA Jig . It is completely
compatible with all of the INCRA joint-
making accessories, including the INCRA
Right Angle Fixture, Stop, and joinery
templates . The setup follows, see
Fig. 12:
Adjust infeed/outfeed fences to
the in-line/mid-range position,
see page 4 .
Adjust fence gap as described on
page 5 .
Follow the instructions for the
joint you wish to cut as detailed
in the INCRA Master Reference
Guide and Template Library.
Fig. 12
Joint Making
Joint Making (INCRA Jig Ultra required)
Clearance is provided for between the Hi-Rise fence cap, the braces
and all INCRA joint-making accessories . However, since the Hi-Rise fence
cap and braces are not necessary for joinery, you may remove them from the
Wonder Fence if you prefer . Just loosen the (2) socket head fasteners that
secure the fence cap braces, and slide the assembly off of the Wonder Fence .
1
2
3
4
5
1
2
3
Vertical Panel raising