INCRA TS-LS Table Saw Fence - Manual (Page 7)

Set final base assembly
position
Loosen the (4) base clamping knobs and slide
the base assembly to locate the near side of
the base support panel at 37 1/4” from the
saw blade. See
Fig. 14. Tighten the clamping
knobs in place. Using a 3/16” hex tool, tighten
the (4) set screws through the holes located
in the base clamps. If you have the 72” Rails,
slide the (2) stop positioners up against the
rear edge of the base clamps as shown and
tighten the hex bolts. Should you ever need to
remove the base assembly from your table saw,
these stop positioners will allow you to return to
the original setup in seconds.
92” RAIL NOTE: If you are setting up an
extended capacity system using the 92” rails,
DO NOT tighten the stop positioners just yet.
Instead, assemble the Floating Stops shown
in the TIP on page 12 and slide them up to
the
front edge of both base clamps (the edge
nearest the blade) and tighten in place. After
completing all of the setup and calibration
instructions from this manual, refer to the
“EXTENDED CAPACITY INSTRUCTIONS”
included in the 92” Rail box to complete your
setup.
6
Align base mount assembly
parallel to miter slot
Take the base mount assembly to the table
saw and, as you lower the base mount onto the
rails, position the (4) clamping knob assemblies
directly under the slots in the base clamps.
Slide the base assembly along the rails to
position the base support panel at 20” from
the miter slot, Fig. 13. Take a measurement
at both ends of the panel. Loosen the Phillips
head screws that hold the base clamps as
necessary to align the panel parallel to the
miter slot. Tighten all (8) screws that secure
the base clamps to the base support panel.
Replace the base support panel end caps.
fig. 14
Set final base assembly position
Base clamp
first: Slide base assembly
to 37 1 / 4
” from saw blade and
tighten all (4) clamping knobs
3 ⁄ 16 ” hex tool
INCRA TS-LS Owner’s Manual 7
5 fig. 13
Align base mount assembly parallel to miter slot
Loosen base clamp
screws as necessary
Base clamp
Base support
panel
Third: Tighten base clamping knobs and
all (8) screws that secure the base
clamp to the base support panel
Miter slot
By loosening the (4) clamping
knobs and set screws, you can
slide the base assembly to any
position along the length of the rails
- great for accessing a router table
extension wing placed to the left of the
blade.
Replace
end caps
first: Lower base
assembly onto rails
and base clamping
knobs
Second: Slide base assembly
to align 20” from and parallel
to miter slot
Base
clamping knob
Third: Slide stop positioners up to
both base clamps and tighten hex
bolts (72” rails ONLY). See note at
left if you have the 92” rails.
Second: Tighten (4) set
screws through holes in
base clamps
Note: This
alignment is a
“rough” preliminary
only. Final fence
alignment is
covered later in
this manual
20”
37 1 /
4
”