INCRA CleanSweep Adaptor - Manual (Page 2)

w w w. i n c r a . c o m
Manufactured by:
Taylor Design Group, Inc.
P.O. BOX 810262 Dallas, TX 75381
www.incra.com
INCRA Tools are protected by one or more of the following US patents:
#4,793,604, #4,930,221, #5,195,730, #5,275,074, #5,423,360, #5,716,045, #6,237,457,
#6,557,601, #6,672,190. rev.05/13
INCRA is a Registered Trademark of Taylor Design Group ©2013 Taylor Design Group, Inc.
MADE IN THE
USA
Plate Leveling Options
As previously mentioned, the CleanSweep Adaptor
provides a variety of options for later leveling your rout-
er plate or lift. Review the options below to determine
the best approach for your situation before mounting
your CleanSweep Cabinet.
OPTION 1: If you plan on using only your existing corner
mounted levelers to level your router plate, you can re-
move the (10) 5/16-18 X 1-1/2” Socket head fasteners,
Fig 3. Tip: The fasteners can also be left in place on the
adaptor. Just screw them down so the head does not
interfere with your router plate.
OPTION 2: If you would like to use some or all the
(10) 5/16-18 x 1-1/2 Socket head fasteners to supple-
ment or replace your existing equipment for leveling
any Non-INCRA router plate, remove then re-install the
fasteners so that the socket heads will be accessible
from the underside of the table,
Fig 4.
OPTION3: If you want to upgrade to any INCRA Mag-
naLock Router Plate or Lift, the fasteners can be left in
place for easy adjustability from the top of the table
through the access holes provided in all INCRA Mag-
naLock Plates and Lifts,
Fig 5.
Fig.6
use shorter
#10x1-1/4” wood
screws with washers
in (2) holes over
Miter Channel
Mounting the CleanSweep Cabinet
Align the CleanSweep Cabinet over the (8) remaining
mounting holes on the adaptor. The Blast Gate Slide
pull tabs should be oriented facing the infeed side of
the table. Through the (2) mounting holes over your
router table’s miter channel, use the shorter #10 x
1-1/4” wood screws with washers to attach the Clean-
Sweep to your table. For the remaining (6) holes, use
the longer #10 x 1-1/2” wood screws with washers,
Fig 6.
You can now return to Step 4 in the CleanSweep Owner’s
Manual to complete your CleanSweep installation.
use longer
#10x1-1/2” wood
screws with
washers in (6)
remaining
mounting holes
Fig.3 Plate Leveling Option 1
remove (10)
socket head
fasteners to use
corner levelers
only
Fig.4 Plate Leveling Option 2
remove then reinstall
fasteners from
bottom to augment
or replace existing
leveling system
Fig.5 Plate Leveling Option 3
INCRA MagnaLOCK™
Plate
leave socket head
fasteners in place
for through the
plate adjustability
with INCRA
MagnaLOCK™
Plates and Lifts
Miter Channel