INFICON DCM-250 Deposition Control Monitor Software - Manual (Page 5)

DCM-250 S PECIFICATIONS
Deposition Controller Software MDC-260/360C/361C can have any software version installed.
MDC-360/361 must have a minimum of software version 3.9e
installed* to use the DCM-250, but 3.9m or later is required to
use the Run Process command.
MDC-370 must have software version 1.2 or later installed*.
See the Sign-On Screen section of the respective Operation
and Service Manual for details on determining the software
version
If your controller doesn't meet these requirements you will need
to contact us and/or your local distributor for details on the
possible upgrade options.
Pentium 233 MHz or faster
(PIII-500 or better recommended) Equivalent processors may also be used, but typically require a
faster speed for the same performance level.
Windows 98SE/ME/2000/XP We recommend that you install the latest service pack prior to
installing this software. Contact Microsoft for more details.
16 MB RAM minimum
In addition to the operating system
requirements. More memory is recommended with later versions of Windows.
1 Communications Port Depending on the hardware configuration of the deposition
controller you will need either an RS-232, RS-485, USB or
IEEE-488 controller card installed in the host computer.
Special hardware drivers must be installed prior to using the
respective function.
SVGA Monitor 800 × 600 minimum resolution.
1024 × 768 or higher recommended.
CD-ROM drive Required for CD-ROM installation, only.
Internet Explorer 5.5 or later The DCM-250's Help system requires Internet Explorer version
5.5 or later to be installed to work properly. If you are using an
earlier release, you will need to upgrade prior to using Help.
11 MB Free Hard Disk Space Additional space is required to record run time data. The exact
amount varies with the Data Points/Minute setting.
* These versions added a new auto-data logging command, which is required by the DCM-250's Monitor
Process screen.