INFICON Hydrostik Hydrogen Fuel Cylinder Installation User Manual

Instruction sheet hydrostik hydrogen fuel cylinder

Advertising
background image

INSTRUCTION SHEET

Hydrostik Hydrogen Fuel Cylinder

Installation Instructions

PN 074-626-P1A

1 of 7

Introduction

Hydrostik™ is a metal hydride hydrogen fuel cylinder that is used as a source of
hydrogen gas in a DataFID™ or MicroFID II™. Hydrostik releases hydrogen at low
pressure to support up to ten hours of instrument operation.

The following installation instructions are provided:

attaching Hydrostik to the Hydrostik adapter

filling Hydrostik using a high-pressure hydrogen tank

installing Hydrostik adapter assembly into a DataFID or MicroFID II

NOTE: These procedures are applicable to both DataFID and MicroFID II.

Hydrostik Related Parts

Hydrostik (PN ISP-951-402-P1 or PN ISP-951-402-P2)

Hydrostik Adapter (PN 951-205-G1)

Foam Insert (PN ISP-951-202-G1)

Attach Hydrostik to the Hydrostik Adapter

NOTE: In order to fill Hydrostik with hydrogen, it must be attached to the

Hydrostik adapter.

Insert the threaded end of Hydrostik into the Hydrostik adapter and screw
Hydrostik clockwise until tight (

Figure 1

).

Figure 1 Attaching Hydrostik to the Hydrostik Adapter

Hydrostik adapter

Hydrostik

Advertising