INFICON Hydrostik Hydrogen Fuel Cylinder Installation - Manual (Page 6)

INSTRUCTION SHEET
Hydrostik Hydrogen Fuel Cylinder
Installation Instructions
PN 074-626-P1A
6 of 7
Install the Filled Hydrostik into the FID
The Hydrostik adapter assembly is ready to be installed and used to fuel the flame in a
DataFID or MicroFID II.
Tools Required
 Phillips #1 screwdriver
Procedure
1 Remove the hydrogen fuel cylinder retention plate from the DataFID or MicroFID II
by unscrewing both captive screws on top (
Figure 7 ).
Figure 7 Remove hydrogen fuel cylinder retention plate
2 Insert Hydrostik adapter assembly into the hydrogen fuel cylinder holder ( Figure 8 )
with the Hydrostik adapter valve in the OPEN position.
Figure 8 Insert Hydrostik into cylinder holder