INFICON IC/5 Offline Editor Software Manual - Manual (Page 7)

1 - 1
IP
N 07
4-
25
4C
IC/5 Off-Line Editor Operating Manual
Chapter 1
Overview
1.1 Introduction
The IC/5 Off-Line Editor software provides the convenience of programming or
modifying the IC/5 Thin Film Deposition Controller's parameters at a personal
computer. The IC/5 Off-Line Editor simulates the IC/5 displays, therefore the
programming process is very similar to the IC/5 itself.
The parameters are stored in configuration files which may be transferred into an
IC/5 using a 720 Kbyte or 1.44 Mbyte floppy diskette. The IC/5 must contain the
floppy disk drive option (IPN 760-023-G1).
The DOS based IC/5 Off-Line Editor software is comprised of the OFFLINE.EXE
executable file. It can be run from DOS or from a DOS window in Windows® 3.x or
Windows 95.
The computer keyboard or a mouse can be used to move about the program.
NOTE: Instructions for programming the IC/5 and complete descriptions of each
parameter are included in the IC/5 Operator's Manual (IPN 074-237).
1.2 Electronic Document Distribution
This manual is available as a PDF document. The PDF file is named offlnedt.pdf
and is located on the diskette containing the IC/5 Off-Line Editor software.
To view the PDF version of this manual, you must have the appropriate Adobe®
Acrobat® Reader installed on your computer. The Adobe Acrobat Reader™ may
be downloaded directly from Adobe through the following:
World Wide Web. . . . . . . . . . . . . . . . http://www.adobe.com
America Online® . . . . . . . . . . . . . . . adobe
CompuServe® . . . . . . . . . . . . . . . . . go adobe
Refer to the information provided by your service provider for instruction on how to
download files. Refer to the information supplied by Adobe for instruction on how
to use the Acrobat Reader.