Belkin F1DN104F - Manual (Page 13)

11
Secure DVI-I KVM Dual-Head Switch with Audio
InSTAllATIon
sections
table of contents 1 2 3 4 5 6 7 8 3
Pre-Configuration
Where to place the Switch:
The enclosure of the Switch is designed for desktop or under-mount
configuration. An optional Mount Kit (Belkin part number F1D008)
is available.
Consider the following when deciding where to place the Switch:
• your proximity to the port selectors on the front of the Switch
• the lengths of the cables attached to your keyboard, monitor,
and mouse
• the location of your computers in relation to your console
• the lengths of the cables you use to connect your computers
to the Switch
Warning: Avoid placing cables near fluorescent lights,
air-conditioning equipment, or machines that create electrical noise
(e.g., vacuum cleaners).
Connection and Installation
Step 1 Connecting the Console to the Switch
Warning: Before attempting to connect anything to the Switch or your
computers, please ensure that all computer equipment and devices
are powered off.
Connect your monitors, keyboard, mouse, and speaker to the rear of
the Switch in the “User Console” section. (Refer to diagram on page 8)
Step 2 Power up
2 .1 Power on the monitors.
2 .2 Power up the KVM Switch by connecting the power. The display
diagnostic LEDs should be solid green a few seconds after
power up. This indicates the display EDID information has been
captured and secured. If the display diagnostic LED remains
blinking for longer than 10 seconds after power up, refer to the
Troubleshooting section of this user manual.