Belkin F1DN104F - Manual (Page 17)

15
Secure DVI-I KVM Dual-Head Switch with Audio
CoMMon ACCeSS CArD (CAC) ConfIGurATIon AnD InSTAllATIon
sections
table of contents 1 2 3 4 5 6 7 8 5
Step 1 Installation
1 .1 Using the included USB cable, connect one end of the cable to
the computer that requires CAC, and the other end to the CAC
port on the KVM Switch that corresponds to the computer.
1 .2 Enable CAC for the same port connection in Step 1.1 by switching
the CAC switch to the right.
1 .3 Repeat steps above for additional computers that require CAC.
Make sure that the CAC switch is disabled (left) for all other
non-connected CAC systems.
1 .4 Once configured, the CAC connection will be switched only when
required by the connected computer. When switching from a CAC-
enabled port to a non-CAC-enabled port, the CAC connection will
remain with the last previously selected port where the CAC was
set to “Enable.”
CAC (Common Access Card) Configuration and
operation
(F1DN104F model only)
CAC connection to the computer requires a separate USB cable
connection and allows the user to specify whether there is a
CAC required for that computer or not. This allows the CAC to be
connected and controlled separately to the keyboard, mouse, video,
and audio.
notice: The CAC functionality was not certified by Common
Criteria. Currently, Common Criteria does not offer any guidelines
for CAC peripheral support in the Peripheral Sharing Protection
Profile. The inclusion of this functionality does not affect the
Common Criteria certification applied to the rest of the product.