Bissell 3-IN-1 VAC 38B1 - Manual (Page 5)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
O
perations
M
aintenance and care
3. As a Multi-Purpose Vacuum:
The crevice tool and floor nozzle may be
used with the hand vacuum. To use for
cleaning in tight spaces, insert the crevice
tool into the opening at the bottom of the
dirt container. Press firmly to secure in
place. To clean a wider surface, remove
the crevice tool and attach the floor nozzle
by inserting it into the opening at the
bottom of the dirt container. Press firmly
to secure in place.
Power cord storage
1. Turn Vacuum off (O).
2. Unplug power cord by grasping the
polarized plug, NOT the cord, and
disconnect from outlet.
3. Loop power cord around cord wraps
on the handle.
4. Clip molded plug to power cord to secure.
To maintain maximum performance from
your BISSELL vacuum, perform these simple
maintenance checks:
Emptying the dirt container
1. Turn Vacuum off (O).
2. To remove dirt from the dirt container
and filter, hold the vacuum vertically as
shown. Depress and hold latch on top of
the vacuum to release the dirt container.
3. Gently pull dirt container away from the
hand vacuum grip and remove the filter
as shown. Empty into waste container.
4. The dirt container may be rinsed with warm
water and a mild detergent if needed. The
dirt container must be thoroughly dried
before replacing.
5. Replace filter. Attach dirt container to
vacuum by depressing Latch and securely
fitting onto hand grip. Make sure dirt
container is correctly secured.
WARNING:
To avoid injury, turn vacuum
OFF and unplug cord from
wall when not in use.
5
5
2 3
(select models only)