Kinetik Blood Pressure BPM4TL - Manual (Page 15)

Using your Blood Pressure Monitor
•
Switching on the monitor
A. Switch on the monitor by pressing START/STOP button.
B. All segments appear on the screen.
•
Taking a measurement
A. With the cuff wrapped around your arm, press START/STOP button to start measurement.
All display symbols appear on the screen for 2 seconds.
B. After all symbols disappear, the display will show “00”. The monitor is “Ready to Measure”
and will automatically inflate to the level that is right for you.
C. After the initial inflation of the cuff, the pressure will slowly decrease and when a pulse is
detected, PULSE SYMBOL will start flashing.
D. When the measurement is finished, the systolic pressure, diastolic pressure, heart rate
and corresponding Risk Category Indicator Bar will be displayed for about 1 minute.
E. Without any operation for 1 minute, the device automatically shuts off.
NOTE :
Do not inflate the cuff unless it is wrapped around your arm.
NOTE :
•
This monitor will re-inflate automatically if the system detects that your body requires
more pressure for measurement.
•
If you experiance any pain during measurement, press the start/stop button to cancel
the cuff inflation.
•
To interrupt the measurement, press START/STOP button to switch to Standby Mode.
14
Measurement Procedure