Kuryakyn 9518 VELOCIRAPTOR AIR CLEANER for YAMAHA - Manual (Page 2)

PAGE
2
STEP 2 Remove existing air cleaner cover, filter element, and backing plate; save the
three socket head cap screws for later use.
OPTIONAL: (950 Models Except Bolt) — Refer to PIC 1. Remove the two
screws to remove the OEM support bracket, it will not be
used; reinstall and tighten the screws. Refer to the service
manual for correct torque specs.
STEP 3
Refer to PIC 2. Disconnect the breather hose from the back-
side of the backing plate. Ensure the spring clip remains on
the hose; it will be reused. Set the backing plate aside, it will
not be reused.
STEP 4 Refer to PIC 2. Remove the lower screw from the timing
chain tensioner housing. Set the screw aside; it will not be
reused.
STEP 5 Refer to PIC 2. Remove the front Phillips head screw from
the bottom of the throttle body. Set the screw aside; it will
not be reused.
STEP 6 Refer to PIC 3. Locate the included Mounting Bracket. Secure
the Mounting Bracket to the underside of the throttle body
with an included M5 X 0.8 X 14MM Socket Head Cap Screw
and M5 Split Lock Washer. Leave the Screw finger tight for
now.
NOTE: Remove one Phillips head screw at a time
to prevent dislodging the plate and O-ring
it secures.
STEP 7 Remove the rear screw from the underside of the throttle
body. Refer to PIC 3. Swing the Mounting Bracket in until the
holes align; secure the Bracket with the other M5 Screw and
Lock Washer. Leave the Screw snug for now.
STEP 8 Align the Mounting Bracket slot with the hole in the timing
chain tensioner housing; thread the included M6 Socket Head
Cap Screw with Flat Washer through the slot and into the
tensioner housing. Leave the Screw snug for now.
STEP 9 Tighten the two M5 Screws from
STEP 6 and 7
. Do NOT over
tighten the Screws. Tighten the
M6 Screw from
STEP 8 .
STEP 10 Refer to PIC 4. Thread the in-
cluded 1/2” Elbow Hose Fitting into
the included Air Cleaner Adapter.
Ensure the Fitting points inward
when installed.
STEP 11
Refer to PIC 4. Install the included
Rubber Inlet Flow Plate in the
Adapter as shown.
VELOCIRAPTOR AIR CLEANER for YAMAHA
-cont.-
INSTALLATION
THROTTLE BODY
REMOVE THE
FRONT SCREW
REMOVE THE
LOWER
SCREW FROM
TIMING CHAIN
TENSIONER
HOUSING
PIC 2
BREATHER HOSE
PIC 3
PIC 4
90 DEGREE
FITTING
POINTS
INWARD
INSTALL RUBBER INLET FLOW PLATE
IN BACKSIDE OF ADAPTER. ENSURE
PLATE FULLY SEATS IN RECESS
Working around the sharp edges of the cylinder-head fins exposes
your hands to injury. Wear protective gloves to prevent serious in-
jury.
MOUNTING BRACKET
FRONT OF BIKE
PIC 1 BRAKE-SIDE (RIGHT)
REMOVE THE TWO SCREWS TO REMOVE BRACKET