Kuryakyn 9518 VELOCIRAPTOR AIR CLEANER for YAMAHA - Manual (Page 3)

PAGE
3
STEP 12
Refer to PIC 5. Hold the Adapter assembly up to the throttle body; attach the breather hose to
the Elbow Fitting and secure it with the hose clip.
STEP 13 Position the Adapter so that the Rubber Plate interlocks with the flange on the throttle body.
STEP 14 Refer to PIC 5. Secure the Adapter to the
throttle body with the three OEM screws
removed in
STEP 2 . Leave the screws
loose until all three have been started, then
tighten.
STEP 15
Refer to FIG 1. Completely disassemble the
Velociraptor Air Cleaner, pay attention to the
location of the parts, as it will be reassem-
bled in reverse order.
STEP 16 Refer to FIG 1. Locate the Velocity Base.
Insert the three included 1/4”-20 X 1/2”
Socket Head Cap Screws through the inside
of the Base.
Locate the included Gasket, align the holes
on the backside of the Base; place it over
the protruding Screw ends.
STEP 17 Align the Screws with the holes and attach
the Base to the Adapter; leave the three Screws loose until all
have been started in their threads, then tighten the Screws.
STEP 18 Snap the Super Ring (shown in BLUE in FIG 1) into place
inside the Velocity Base.
Install the Filter Element; place the Screen and Velocity Cap
over the Filter and secure it all with the five included 1/4”-20
X 1/2” Socket Head Cap Screws.
STEP 19
Ensure there is sufficient hose clearance and check the throt-
tle for correct operation, making sure it returns properly, BE-
FORE starting bike.
VELOCIRAPTOR AIR CLEANER for YAMAHA
Ride On!
INSTALLATION
FIG 1
SUPER RING
FILTER ELEMENT
SCREEN
VELOCITY CAP
Ensure that the installation of this product does not interfere with the
proper operation of the motorcycle before riding.
It is the end user’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not provide warranty coverage on products or compo-
nents lost due to improper installation or lack of maintenance. Periodic in-
spection and maintenance are required on all fasteners.
VELOCITY BASE
ATTACH THE
BREATHER
HOSE TO THE
FITTING
PIC 5
SECURE
THE
ADAPTER
TO THE
THROTTLE
BODY WITH
THE THREE
OEM
SCREWS
BOLT MODEL SHOWN
If the OEM exhaust system is replaced or altered (in addition to
replacing the air cleaner), then install Kuryakyn P/N 9218 Wild
Things Fuel Controller to prevent a “lean” fuel/air mixture that
can result in over heating leading to engine damage.