Kuryakyn 9422 HYPERCHARGER for YAMAHA V-STAR 650 - Manual (Page 3)

PAGE
3
STEP 4
The opening in the adapter boot must be slipped over the flange of the stock airbox and secured
with the stock clamp. Install the mounting bracket as shown in PIC.3. Secure this
assembly to the bike with the hardware specified in the previous step.
STEP 5
See PIC.4. Plug the extension into the float bowl vent hose and add the short
section of hose included. This will plug into the 90 degree fitting on the back side
of the Hypercharger.
STEP 6
See PIC.5. This step can be performed without disassembling the air cleaner. The
front half was removed here for a better picture. Only the round “trap door” need
be removed. “Work” the radiused flange of the adapter into the inlet hole of the air
cleaner.
STEP 7 See PIC.6. Fold the radiused flange back to expose the three mounting holes.
Secure the air cleaner to the bracket using the three 1/4–20x1/2” Socket head cap
screws and Nylock nuts.
STEP 8
Replace the trap door on the Hypercharger. Connect the newly extended float
bowl vent hose to the 90° fitting installed on the back of the air cleaner. On the
left side of the engine, next to the front cylinder you’ll see the two chrome lines
that go to the fresh air pump. The small rubber hose clamped to these lines is a
vacuum hose. Find the splice in this vacuum hose. Remove the splice, and in its
place insert the enclosed “T” fitting. Run the enclosed length of vacuum hose from
this “T” fitting to the vacuum nipple on the bottom of the Hypercharger.
PIC.6
STEP 9
Double check the tightness of all related fasteners, check for hose
clearance and check throttle for correct operation, making sure it returns
properly, before starting bike.
ROTATE THROTTLE AND CHECK THAT IT MOVES FREELY AND
RETURNS TO CLOSED BEFORE STARTING BIKE. FAILURE OF
THE THROTTLE TO RETURN COULD RESULT IN LOSS OF
CONTROL CAUSING SERIOUS INJURY OR DEATH.
It is the installer’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the
motorcycle. Küryakyn will not provide warranty coverage on products
or components lost
due to improper
installation or lack of
maintenance.
Periodic inspection
and maintenance are
required on all
fasteners.
Ride On!
HYPERCHARGER for YAMAHA
INSTALLATION
PIC 3
FLOAT BOWL
VENT HOSE
HOSE EXTENSION
PIC 4
RADIUSED
FLANGE
PIC 5
PIC 6
FIG 1