Page | 9 rear panel – KV2 Audio ESP4000 User Manual
Page 9
WWW.KV2AUDIO.COM
DESIGNED BY KV2 AUDIO
MANUFACTURED IN THE EUROPEAN UNION
SERIAL NUMBER
1
0dB
-6dB
1
2
3
4
min. 2
2
0dB
-6dB
3
0dB
-6dB
4
0dB
-6dB
min. 2
min. 2
min. 2
250 VAC
230 VAC
115 VAC
WWW.KV2AUDIO.COM
DESIGNED BY KV2 AUDIO
MANUFACTURED IN THE EUROPEAN UNION
SERIAL NUMBER
1
0dB
-6dB
1
2
3
4
min. 2
2
0dB
-6dB
3
0dB
-6dB
4
0dB
-6dB
min. 2
min. 2
min. 2
Page | 9
Rear Panel
1
2
3
4
1) Channel Input Level Adjustment
Each channel of the ESP4000 features an Input Level adjustement potentiometer that allows the
user to individually adjust all four channel’s input levels from oo through -6dB in the vertical position
and up to to 0dB.
2) Main Inputs
These are the input connectors for all four channels with associated ‘Through Output’ connectors
for sending signal to other devices.
3) PowerCon Power Connectors
The ESP4000 uses one connector per two channels. Both must be connected to operate all four
channels of the ESP4000. Half of the channels will be fully functional if only one is connected.
They accept standard PowerCon terminated AC Mains cables.
4) Fans
The cooling fans operate continuously while the ESP4000 is on. An internal temperature sensor
increases the speed of the fans during high temperature conditions. Air enters through the front
grille and exits through the rear. Be sure to allow adequate air flow to the front of the rack in which
the ESP4000 is mounted.
5) Main Outputs
Each channel of the ESP4000 is equipped with binding posts and Neutrik Speakon® connectors on
the Main Outputs. The minimum recommended output is 2
W.
5