L.A. Baby West Coast Gate SG-35 - Manual (Page 2)

-2-
Installation and operation
1.Measure the width of the opening where you intend to install the gate. Please refer to the following diagrams (1A, 1B, 1C, 1D, 1E ) to
determine the correct installation configuration.
1A
1B
Item:ESG35-0(No ext.)
77 ~ 82cm
(30.30"~32.28")
Item:ESG35-1(9cm ext.x1)
86 ~ 91cm
(33.85"~ 35.82")
1C
Item:ESG35-2(9cm ext.x2)
96 ~ 100cm
(37.79"~ 39.37")
1
2
3
4
5
6
7
8
9
Gate Panel
Gate Frame
Right Upper Corner
Upper Locking Set
Release Button with Latch
Tension knobs
Bolts with Rubber Pads
Mounting Cups
Lower Locking Set
1
1
1
1
1
4
4
4
1
NO. Parts Name Qty.
Parts List
10
11
Long End
Extension Frame
4
2
5
8
7 6 3 4
1
9
2
10 11
1D
Item:ESG35-3(9cm ext.x3)
105 ~ 110cm
(41.33"~ 43.30")
1E
Item:ESG35-4(9cm ext.x4)
114 ~ 120cm
(44.88"~ 47.24")
2.To use with extension frames, please follow the steps below.
a. insert the extension pins into the holes on the outside of the Gate Frame.
Note: the long ends of the pins go into the Gate Frame,
while the short ends go into the long ends of the Extension frames.
b. slip the extension frames over the pins.
c. slide the tension bolts with rubber pads completely Into the holes on the outside of the extension frames (2A)