L.A. Baby West Coast Gate SG-35 - Manual (Page 6)

If the gate does not stay closed:
Upper Locking Set is too close to Right Upper Corner.
Solution: Adjust the upper tension knobs by turning them outward, so that there is a proper distance between the upper latch set
and the corner.
If the gate does not stay in position:
Gate may not install properly as step 3 (3A,3B), remove and reinstall the gate, make sure the gate is installed vertically.
Troubleshooting
-6-
10.To hold the gate open for easy walking through:
The hold-gate-open system can be used by adults only. Once the gate is held open, the automatic closing
feature of the gate will not work anymore, so your child could move back and forth without restriction.
Swing the gate to the open positions to hold the gate open for easy walking through. (Fig.1 / Fig.2)
Gate in closed position
1
2
Top view
Swing to the open positions
!
WARNING
CLEANING:
Clean the safety gate using warm water and a mild detergent. Use a soft cloth or sponge to avoid scratches.
Never use solvents or chemicals to clean the safety gate.
CARE
ATTENTION
1.Do not use the product if any components are broken or missing. Do not use replacement parts other than those
approved by L.A. Baby.
Non approved spare parts may render the repair or the product unsafe.
L.A. Baby Juvenile Products
2.Check regularly that all fittings and components are secure and that no components are worn,
broken or missing.
3.Check regularly that all fittings are securely tightened and that the locking mechanism is working properly.
4.For more information on setting up this gate go to www.lababyco.com and click on instructions
注意
Any additional and replacement parts should only be obtained from .
Customer service hotline: 800-584-3094
L.A. Baby
Juvenile Products
16039 Loukelton Street - City of Industry,
California 91744 - Toll free customer service: 800-584-3094 -
e-mail: [email protected]
and then click on ESG35.