Longevity WeldAll 160PI/200PI/250PI - Manual (Page 14)

160PI/200PI/250PI AC/DC Series IGBT Machines
www.longevity-inc.com 13
Installation and Setup Instructions:
The item numbers referenced in the following paragraphs, refer to the numbered parts display in the diagrams
shown below. Longevity has an instructional setup installation video on our website at
www.longevity-inc.com ,
which we ask that you view prior installing the unit. The video shows the complete assembly of the machine.
The video is located in the Resources section of the website under manuals and installation/set-up videos.
Connecting the electrical plug to the unit
Connecting the power plug to the unit is important. Please view the proper connection instructions below:
Wiring Introduction
Danger: Read this manual completely before having your electrician attempt to wire up or connect your
machine to an electrical power source. Longevity units should be wired by a certified electrician to insure your
safety and a proper 220v plug match at your operating facility. 220v plugs come with 3 or 4 prongs on them.
Have the electrician check your existing receptacle.
Note: The power cord on single-phase machines has one ground wire and two hot wires when connecting to
220vac. Connecting these wires properly is extremely important. Improperly connected wires will void the
warranty, affect personnel safety, and possibly damage your machine and electrical power outlet.