Longevity WeldAll 160PI/200PI/250PI - Manual (Page 25)

160/200/250PI AC/DC Series IGBT Machine
www.LWELD.com
Check List Suggestions
Connect the air supply to your Longevity Plasma
Cutter and consult your owner's manual to ensure the
correct PSI. The PSI is about 65-75.
Each Longevity Plasma Cutter, regardless if it uses
Pilot Arc or High Frequency technology, comes with
an air flow regulator and water catcher. Reference
the owner's manual of your Longevity Plasma Cutter
for specifications and care instructions of your air
flow regulator and filter.
Check the torch of your Longevity Plasma Cutter
and make sure everything is in order. Reference the
owner's manual of your Longevity Plasma Cutter to
make sure all of your consumables are clean, correct,
and pieced together securely before you begin
cutting.
Gouging or piercing can be achieved by simply
lowering the amperage output and keeping with the
recommended psi. Examples on how to achieve the
desired results can be referenced in the owner's
manual of your Longevity Plasma Cutter.
Now you are ready to use your Longevity Plasma
Cutter safely and efficiently. Turn the machine on
and enjoy the satisfying experience of a quality
Longevity Plasma Cutter.
Double check your air supply, air flow regulator and
water filter. (More on this below.)
All Longevity Plasma Cutters require a solid ground
connection as close to the work piece as practical.
Remember, even though your Longevity Plasma
Cutter can cut through paint and other coatings on
the metal, the ground connection requires a clean,
flush connection to the work piece.
Utilizing the proper safety equipment is just as
important as understanding how to properly operate
your Longevity Plasma Cutter. Consult the owner's
manual of your Longevity Plasma Cutter to be sure
you are using the correct gloves, eye protection,
welding leathers, face shield, etc. You can find all of
the necessary equipment as stated in the owner's
manual of your Longevity Plasma Cutter in the
accessories section of our website.