Marshalltown PC3000T Tectonic Plate Compactor Owner's Manual - Manual (Page 18)

ECCENTRIC OIL
Check eccentric oil monthly. Change oil every 300 hours. Check oil by removing oil plug on side of eccentric housing. Oil should be leveled with bolt
hole, see figure 1. If oil is required, use SAE 30 oil. DO NOT OVERFILL.
HARDWARE
Check daily for tightness. If required, tighten using torque charts in Parts Section.
BELT TENSION
Check belt tension weekly.
BELT ADJUSTMENT
Belt is adjusted by loosening four engine bolts and adjusting the engine puller bolt on rear of the engine deck, until desired tension is obtained - then
retighten engine bolts. Adjustment should be made when eccentric is down. Using a straight edge maintains sheave alignment while tightening
engine mounting bolts. Proper tension is obtained when a two lb. force is applied midway between the two sheaves and a 1/4" to 1/2" (6.4 mm to
12.7 mm) deflection of the belt is obtained. For best performance and longest belt life, use only MARSHALLTOWN specified Kevlar belt.
Adjust belt tension by adjusting engine with puller bolt.
Figure 1
Decal M55548
▲
▲
Bolt Hole
Decal
MAINTENANCE
18
55541
If safety or hazard decals or operator's
manual are missing from this equipment,
contact the manufacturer immediately at
1-800-888-0127 or (641) 753-5999
Si las etiquetas de seguridad o peligro o el
manual del operador faltan en este equipo,
contactar inmediatamente al fabricante al
1-800-888-0127 or (641) 753-5999.
NOTICE
AVISO
55546
IDLE ENGINE 5 MINUTES
BEFORE STOPPING
TO IMPROVE SERVICE LIFE
DEJE FUNCIONAR EL MOTOR EN
VACIO DURANTE 5 MINUTOS ANTES
DE DETENERLO PARA EXTENDER SU
VIDA DE SERVICIO.
SET ENGINE SPEED TO
3400+/-50 RPM
55547
AJUSTE LA VELOCIDAD DEL MOTOR A
55549
Read and understand operator's manual
before using this machine.
Follow safety and alert symbols and warnings.
Open flame, fire and smoking prohibited.
Do not operate in unventilated area.
Stop engine before refueling.
Use unleaded gasoline, octane rating of 86 or
higher.
Check the engine oil level before starting.
Hearing protection required.
Lea y entienda el manual del operador antes de usar esta
máquina.
Siga los símbolos y advertencias de seguridad y alerta.
Está prohibido prender fuego, exponer a las llamas y fumar.
No haga funcionar en ambientes carentes de ventilación.
Detenga el motor antes de suministrar combustible.
Utilice gasolina sin plomo de 86 octanos o superior.
Compruebe el nivel de aceite del motor antes de empezar.
Se requiere protección para los oídos.
Moving parts can crush and cut.
Do not operate with guard removed.
Shut off engine to clean or service.
Las partes móviles pueden ocasionar
cortes y aplastamientos.
No operar la máquina cuando no esté
colocado el protector.
Desconectar la máquina para limpiarla o
realizar el servicio técnico. 55550
NOTICE
LIFT POINT
AVISO
55551
Punto de izamiento