Marshalltown Truss Screed - Manual (Page 15)

15
OPERATIONS
SECTION 1
END HANDLE ASSEMBLY
The following figure shows the proper way to mount a standard end handle to the screed section. Do not try to modify this mounting
procedure, this is the only way to mount the end handles where they will work properly.
Always follow the steps below to properly mount the end handles to your screed.
• Mount the bearing onto the bearing support bracket.
• Mount the handle grips onto the lifting handles.
• Mount the lifting handles onto the end handle using two 3/8 x 2 bolts and 3/8 nylon lock nuts.
• Mount the bearing support bracket to the end handle using four 1/4 x 1 1/2 bolts and 1/4 stovernuts.
• Mount the end handle to the screed using three 1/2 x 3/4 bolts, three 1/2 x 1 bolts and six 1/2 hex nuts. Screw the appropriate
adaptor for the end you are working on onto the top pipe. Next, using a 1" flat washer , screw the end handle bolt onto the adaptor.
• Tighten all fasteners after the end handle is completely assembled.