Mayline Meeting Plus - Manual (Page 2)

Assembly:
1. Assemble Glides (E4) into inner most threaded holes in Leg (3). Install End Caps (E5) into Leg (3). See Fig.#1
2. Slide the Axle (E3) into the Wheel (E2) and attach Axle (E3) to Leg Assembly (3) using Screws (E1). See Fig.
#2
3. Attach the Grommet Edging (E7) to Modesty Panel (2) on each end. See Fig. #3
4. Place Top (1) face down on a clean flat surface. Attach Leg Assembly (3) onto Top using six Screws (E1) &
six Washers (E8) per Leg. See Fig. #4 DO NOT TIGHTEN AT THIS TIME.
5. Attach Modesty Panel (2) to Leg Assembly using one Screw (E1) per Leg.
Note: Screws are pre-assembled into leg during manufacturing. May need to move screw to other side of Leg.
See Fig. #5.
6. Tighten all Screws (E1).
7. Attach Modesty Panel to Top using Screws (E6). No pilot hole necessary. See Fig. #5
Tip: On multiple tables always assemble the same leg on the same side. When the tables are next to each other
you have wheels on one leg and levelers on the other.
(2)
Fig. #1