Meade Instruments LX600 - Manual (Page 64)

AutoStar #497 HANDBOX
Appendix F
64
base. The desired hole is located at the curved end
of the telescope drive base (see Fig. I). Be sure
to leave approx, 3/4" of the screw exposed to
allow for clearance of the wedge tilt plate.
2. Grasp the two fork arms of the telescope fi rmly,
with the control panel toward the fl oor, place the
telescope onto the wedge tilt plate (Fig.C, 1) by
sliding the mounting screw on the telescope base
into the slot at the top tilt plate (Fig. J).
3. Insert the center mounting bolt (Fig. K) through
the center of the underside of the tilt plate and
into the underside of the drive base. Firmly
tighten the bolt. Do not overtighten.
Note: It is important to insert the center mounting bolt into the
wedge-telescope assembly. The center mounting bolt insures the
precise pointing accuracy of the X-Wedge.
4. Insert the two remaining 3/8" hex screws
through the underside of the tilt plate (Fig. L)
and into the underside of the drive base. Firmly
Figure J. The telescope drive base placed on the
X-Wedge tilt plate.
tighten all three 3/8" hex screws at this time. Do
not overtighten.
The telescope is now fully mounted onto the wedge and fi eld
tripod. Adjustments in wedge latitude angle and/or azimuth
orientation may be made with the telescope in place.
Setting the Observing Latitude
Look up the latitude of the desired observing site (most road
maps show latitude lines). Then, loosen the latitude lock screws
(Fig. C, 3) and rotate the fi ne latitude control knob (Fig. C, 9)
while reading the latitude scale (Fig. C, 5). The latitude pointer
is a vernier scale (Fig. C, 4) which will allow the tilt angle to be
set to within 0.25°. When the tilt plate is aligned with the desired
latitude, tighten the latitude locking screws.
Aligning the Magnetic Compass
With the aid of the magnetic compass, a telescope can be polar
aligned in locations where the view of Polaris is obstructed
or even before the skies get dark. The compass face has an
angular scale from 0 to 360 degrees which will be useful in
adjusting for the local angle of Magnetic Declination—the
difference between Magnetic North (which the compass shows)
and true north (where the telescope should be pointed).
Note: Magnetic Declination should not be confused with the
astronomical term “Declination” which, when used with “Right
Ascension,” describes the celestial coordinate system.
1. Setting Magnetic Declination:
a. In order to obtain an accurate reading using the
compass, you fi rst need to determine the
Figure K. Attaching the center mounting bolt.
Figure L. Use the provided hex wrench to secure the three 3/8"
hex screws into the telescope drive base.