Memmert AtmoCONTROL - Manual (Page 6)

6 D24042 | Date 09/2014
AtmoCONTROL
1. Introduction
1.1 Description
AtmoCONTROL is a software for programming and logging MEMMERT appliances of the
generation 2012 of appliances (from October 2012) with Ethernet and/or USB interface and
corresponding equipment.
With AtmoCONTROL, you can
►
graphically create, modify and save programmes on your computer with various param-
eters and transfer these to the appliance (description from page 13);
►
read out, organise and document the internal log memory of appliances (description from
page 28);
►
configure user authorisations on USER ID USB sticks, with which the manual adjustment
of individual or all parameters on the appliance can be prevented (description from page
29).
1.2 Supported MEMMERT appliances and parameters
Using AtmoCONTROL, programmes can be created and transferred, protocols read out and
USER IDs configured for the following appliances of the generation 2012 of appliances (from
October 2012):
Appli-
ance
Programmable main parameter
Tempe-
rature
Humi-
dity
Pressure CO
2
O
2
Fan speed Air fl ap Light*
UN PLUS 
– – – – –
 
UF PLUS 
– – – –
  
IN PLUS  – – – – –  
IF PLUS 
– – – –
  
SN PLUS 
– – – – –
 
SF PLUS 
– – – –
  
HPP
 
– – – – –

IPP PLUS 
– – – – – –

ICP

– – – –

–

ICH   – 
* –  – 
* additional option
For all other MEMMERT appliances of the generation 2012 of appliances, protocols can only
be read out using AtmoCONTROL via Ethernet (see page 28); parameters can only be set on
the appliance itself.