Memmert IFP 400 - 800 Incubators (Generation 2003) - Manual (Page 44)

PERFECT page 44
Programming example steriliser
The steriliser (SFP600) has to sterilise at a temperature of 180°C and a medium quantity of load for one
hour and 30 minutes. By setting a cooling time the load can only be removed after it has cooled down.
sterilisation time heating time
180°C
cooling time
°C
t=time
1. Select operating mode “Programme“
After holding down the SET key (approx. 3 sec) the current operating
mode is flashing. Hold down the SET key and select operating mode
“Programme“ using the push/turn control.
After the SET key has been released, the controller is in the “Programme”
operating mode.
PRINT SETUP
2. Edit programme
Hold down the SET key and turn the push/turn control to select “EDIT”.
After the SET key has been released, the controller is in the programme
writing mode.
3. Immediate programme start
Hold down the SET key and turn the push/turn control to select INSTANT
START.
4. Select duration of first ramp segment
Turn the push/turn control to select the time indication.
Hold down the SET key and set the time 00:01 using the push/turn
control.
h
5. Set temperature of first ramp segment
Turn the push/turn control clockwise until the temperature display is
flashing.
Hold down the SET key and set the required temperature setpoint of
180 °C using the push/turn control.
˚C
6. Set fan speed for first ramp segment
Turn the push/turn control clockwise until the fan symbol is flashing.
Hold down the SET key and set the fan speed to 100% using the
push/turn control.
The fan motor is running at
maximum speed.