MMF POS Advantage Series Cash Drawer (C1 Body Size) 18.8 x 20 - Manual (Page 7)

Advantage User Manual
Last revised: 9/1/2012
6
 The Multi Serial Interface comes with factory default settings which are set so that
any one (1) ASCII character will open the cash drawer and the RS-232 settings are auto-
detected automatically by the cash drawer. To modify the cash drawer settings by adjusting
the dipswitches remove the two side screws to access the serial PC board and locate the
three banks of DIP switches SW1/SW2/SW3 and follow the procedure detailed in the
Multi-Serial Interface Operators Manual which came with your drawer or could be
downloaded from www.mmfpos.com to verify correct settings.
 Follow test procedure detailed in the Standard Serial Interface Manual to verify
proper operation of the interface.
Standard - Serial Interface
The Standard-Serial Interface has been designed to open the Advantage Series electronically through the
serial port of the computer.
 Connect the power supply by plugging the small plug tip to the interface recepticle
in the back of the cash drawer. Plug the power adapter end into a 120 Volt AC
Recepticle. Make sure the Green LED on the back of the cash drawer is ON.
 Uncoil the interface cable and securely fasten to COM1 or COM2 of the computer.
 Follow test procedure detailed in the Standard Serial Interface Manual that came with
your drawer or could be downloaded from www.mmfpos.com to verify operation of the
interface.
Printer-Driven Interface
The printer-driven Interface has been designed to use the Advantage Series with a variety of POS printers by
connecting printer specific cables. The corresponding printer specific cable is NOT included with the cash
drawer and should be purchased separately through a dealer or online at:
http://mmfpos.com/index.php/connectivity/cables/kwickkable-rj12-cable.html
 Connect one side of the corresponding printer-specific MMF RJ-12 Cable to the
interface connection located under the cash drawer. The end of the cable that has a label
with the MMF cable part number will plug into the Cash Drawer and the end that has a
label that reads: “Connect to Printer” would plug into the receipt printer.
 Follow the set-up instructions from the printer manufacturer to properly connect the cash
drawer to the receipt printer.
Software Drivers
MMF offers application developers and end users most of the choices available for cash
drawer control. OPOS Drivers are used by developers for its built-in networking
capabilities, which makes it easy to connect a variety of current and legacy retail device
peripherals, PCs, servers, and services in the retail and hospitality markets that work together
on a single point-of-service system.
To download the MMF OPOS DRIVER Version 1.13 visit our website at
www.mmfpos.com > Software Drivers
 The user installing the MMF POS software and configuring the cash drawer devices on Windows 2000, Windows XP, or
Windows 7 is required to have Administrator Rights. Once the software is installed, all users with normal rights can use it.
Warning!
Do not use the
MMF OPOS
drivers if the
cash drawer
connects
directly to a
receipt printer.