MTS Series 242 Actuators - Manual (Page 19)

242 Actuator Force Specifications
Series 242 Actuator Product Information Introduction 19
242 Actuator Force Specifications
242 Actuator Dimensions
Actuator Force Specifications
M ODEL * F ORCE R ATING †
P ISTON A REA R OD D IAMETER
K N K IP MM 2 IN 2 MM IN
242.00 2.7 0.6 136 0.21 28.6 1.12
242.01 4.5 1.0 271 0.42 28.6 1.12
242.02 10.0 2.2 594 0.92 28.6 1.12
242.03 15.0 3.3 760 1.18 28.6 1.12
* Each model has a standard stroke length of 101.6 and 152.4 mm (4
and 6 in). This value is total stroke minus the total cushion length, 12.7
mm (0.50 in). Optional stroke length in 25.4 and 50.8 mm (1.00 and
2.00 in).
† Nominal force with 17.2 MPa (2500 psi) pressure drop across the
piston. Actual force may be up to 20% higher depending on servovalve
size and test conditions.
Actuator Dimensions
D YNAMIC S TROKE
(A LL M ODELS )
D IMENSIONS *
A B C
MM IN MM IN MM IN MM IN
25.4 1 40.64 1.6 215.9 8.5 322.07 12.68
50.8 2 66.04 1.6 215.9 8.5 347.47 13.68
101.6 4 116.84 4.6 279.4 11.0 461.77 18.18
152.4 6 167.64 6.6 660.2 13.0 563.37 22.18
* The dimensions listed are shown in the following figure.