Connecting hydraulics-242 actuator, Connecting hydraulics-242 actuator 30 – MTS Series 242 Actuators User Manual

Page 30

Advertising
background image

Series 242 Actuator Product Information

30

Connecting Hydraulics-242 Actuator

Installation

Connecting Hydraulics-242 Actuator

Hydraulic connections to the Series 242 Actuator are made through a manifold
that connects the ports of each end cap. The manifold has hydraulic pressure,
return, and drain ports stamped P, R, and D, respectively. These ports are
connected to matching ports located on a hydraulic service manifold (HSM).

Note

When the Series 242 Actuator is installed in a load unit, the hydraulic
connections are made through a manifold.

Do not use inferior quality hydraulic fluids.

Using fluids other than those specified by MTS may cause component or
system failure or both.

Use Mobil DTE 25 or Shell Tellus 46 hydraulic fluid only.

Servovalve
Hydraulic
Ports

Servovalve
Mounting Holes
(each corner)

Return Port

Drain Port

Pressure Port

CAUTION

Advertising