MTS Bionix EnviroBath - Manual (Page 37)

Bionix® EnviroBath™ Chamber Maintenance 37
Maintenance
Periodic cleaning Maintenance of the Bionix EnviroBath chamber consists of periodic cleaning and
seal inspection.
Before cleaning, disassemble the chamber and extension rod feed-thru seals to
the extent necessary to inspect for build-up of deposits.
To clean the unit, use a mild detergent and a clean, lint-free cloth. Rinse
thoroughly to remove detergent deposits and dry with a clean, lint-free cloth.
Seal inspection O-ring seals, fittings, and pipe thread sealant should be inspected at each use and
replaced if leakage is noticed. When replacing seals, ensure that the seam is at the
top. The seals can be removed by pulling them out of the channel. The seals can
be installed by starting with one end top center, and pushing the seal into the
groove with a thumb or finger. Never use a sharp objects to install seals.
Heating circulator
bath operation
A manual describing maintenance of the heating circulator bath is provided by
the vendor.