MTS Advantage Wedge Action Grips - Manual (Page 26)

Manual Name Operation 26
The wedge springs can become dislodged and fly out of the grip assembly.
The wedge spring can attain a force that can hurt you.
Ensure that the retaining clip is installed on the spring anchor post.
2. The lower end of the wedge spring is secured to the spring post with a
retaining clip (star washer). If the retaining clip is not present, install one
before disconnecting the spring from the wedge. Disconnect the springs that
are attached to each wedge.
3. Remove the two screws securing the retaining guides and remove the
retaining guides.
4. Remove the wedges from the grip body.
5. Remove any debris from the grip body that might have collected during
testing.
6. Apply a thin coat of Nikal lubricant to the surfaces of the wedge that contact
the grip body.
7. Place the wedges in the grip body.
8. Replace the retaining guides so that the pin on the wedge is in the slot.
Secure with two screws.
9. Replace springs on each wedge.
WARNING