MTS Fundamental Pneumatic Grip Controller - Manual (Page 7)

Installation
MTS Fundamental™ Pneumatic Grip Controller Product Manual 7
Installation
1. Disconnect power to the pneumatic grip controller.
Note To release the tubing, press in the locking collar (see 3 on the previous
page) and pull the tubing out of the connection.
2. Using the supplied tubing and cutter, cut the tubing to the appropriate
length.
3. Push the tubing into the four grip connections firmly.
4. Connect the foot switch to the Switch Connection.
5. Firmly push the tubing into the Compressed Air Input.
6. Connect E-stop Input.
7. Connect E-stop Output. This connector allows you to pass the E-stop signal
to another device. If the pneumatic grip controller is the last device in the E-
stop chain, this connector must be terminated (jumpered).