MTS Model 506-62-72 Hydraulic Power Supply - Manual (Page 29)

Installation 4-1
Section 4
Installation
Introduction This section provides the following installation information for the
Model 506.62/.72 Hydraulic Power Supply (HPS).
• hydraulic connections
• electrical connections
• water connections
Before you complete
connections Perform these steps before you make any connections to the HPS.
1. Remove the shipping plate located under the hydraulic fluid
filler cap.
2. Make sure that the chained jumper plug is connected to the remote
control connector located on the side of the starter box door. See
the figure below.
Remote control
connector
Figure 4-1. Location of Remote Control Connector
For remote control
connection The jumper plug may be replaced by the system cable from a remote
control device when the HPS is ready for system operation.