MTS Multipurpose Getting Started - Manual (Page 7)

1.2.3.0 Launch the Simulation Software
1. Launch the MTS Series 793 Station Manager application:
• Double-click the Station Manager icon located on your desktop, or
• Click Start > Programs > MTS 793 Software > Station Manager.
Station Manager Icon
2. In the Select Project window, select Project1 and click Open.
This step may not be necessary if Project1 was selected as the default when the software was installed.
3. Select TestSuite Simulation (MTS FlexTest 40), and then click OK. This step selects the controller used
by the station configurations in this guide.
MTS TestSuite Simulation Selection
4. In the Open Station window, select Virt_3-02_CF_LCF.cfg and click Open.
This opens the station configuration that was used to create the example test file provided with your
software.
5. Minimize the Station Manager application.
At this point, the station configuration is loaded and the Station Manager application is providing real-time
control of the simulated test station. You perform all other tasks with the Multipurpose Elite application.
Note:
With the Station Manager main window minimized, close all other Station Manager windows, such
as the Scope, Meters, and Display Setup windows.
6. Start the Multipurpose Elite application:
• Double-click the Multipurpose Elite icon on your desktop, OR
MTS TestSuite 7
1.0 Introduction