MTS Model 632-85 Biaxial Extensometer - Manual (Page 6)

Model 632.85 Biaxial Extensometer 6 Introduction
The design of the conical contact points allows the extensometer to be used on a
wide variety of specimens. These same conical points are usable on specimens
with circular as well as rectangular cross sections.
Item Description
1 Plus specimen dimension R
2 Specimen dimension R
3 Axial sensor unit A
4 Specimen dimension S
5 Transverse sensor unit
6 Grip pads
7 Positioning arm
8 Loosen these screws to adjust for specimen dimension R
9 Slide bracket
10 Compliance flexure
11 Axial sensor unit B
12 Zero set pin
13 Axial gage length
14 Conical point
15 Overtravel stop plate