MTS Series 252 Servovalves - Manual (Page 28)

Series 252 Servovalve Product Information 28
252 Servovalve Cable Connections
Installation
252 Servovalve Cable Connections
The following figure shows the connector wiring for the servovalve. The correct
wiring configuration is determined by the requirements of the device used to
control the servovalve. See the appropriate controller manual for information on
servovalve connections. Common MTS cables include:
• For a single Model 252 servovalve, part number 397006-xx
• For dual Model 252 servovalves, part number 397007-xx
Wiring Diagrams
MTS Controller
backshell
Reverse leads A and D
for servovalves phased
the same hydraulically
Coils Series
Differential
Parallel
Connector
Drain
valve command2
valve command2
valve command2
valve command1
MTS Controller
backshell
Drain
valve command2
valve command2
valve command2
valve command1
Total
Dual
Servovalves
80 Ω
80 Ω