Maintenance, Lubrication – Multiquip ST41460 User Manual

Page 21

Advertising
background image

st4/st6 series submersible pumps• operation anD parts manual — rev. #1 (11/12/13) — page 21

mainTenanCe

lubrication

To check the lubrication oil level of the mechanical seal

perform the following:
Checking Lubrication Oil Level

1. Lay the pump (Figure 16) on its side with the oil plug

facing upwards.

2. Remove oil fill plug.
3. Visually inspect oil plug hole to verify that oil chamber

is full enough to cover seal spring.

4. When reinstalling oil fill plug, apply teflon tape to

prevent leaking.

Changing Lubrication Oil

1. If lubrication oil level is low, block the oil fill opening

with a finger and roll pump to one side to drain oil into

a small container.

Use a funnel (Figure 16) and fill oil chamber with ISO

VG32 lubrication oil or equivalent. Oil chamber

capacity is 40 oz. (1,200 cc) for ST41230/ST41460 and

47 oz (1,400 cc) ST61230/ST61460. Fill to 75-80%

capacity to allow for expansion. Replace lubrication oil

once a year or 3,000 hours.

Figure 16. Adding Lubrication Oil

Warning

When removing oil fill plug, please note

that pressure may have built up in the oil

chamber.

Do not fully remove plug until

pressure has been relieved. Turn oil fill plug

slowly to relieve pressure.

FILL TO 75-80% CAPACITY

FILL WITH ISO VG32 LUBRICATION

OIL OR EQUIVALENT.

REMOVE FILL PLUG, AND

VISUALLY INSPECT THAT

OIL CHAMBER IS FULL ENOUGH

TO COVER SEAL SPRING.

CHECK HYDRAULIC OIL ONCE

A YEAR OR EVERY 3000 HOURS.

LAY PUMP FLAT

ON ITS SIDE

Inspecting Lubrication Oil (Mechanical Seal)

1. Block the oil fill opening with a finger and roll pump to

one side to drain (Figure 17) oil into a small transparent

container.

2. If oil is cloudy (milky) or has water in it, indicates

that mechanical seal is defective or worn. Replace

mechanical seal.

Figure 17. Lubrication Oil Inspection

LAY PUMP FLAT

ON ITS SIDE

DISCOLORATION OF OIL (MILKY)

INDICATES A WORN OR DEFECTIVE

MECHANICAL SEAL. REPLACE

MECHANICAL SEAL.

OIL FILL

OPENING

NOTICE

When replacing the oil in the oil chamber, shaft seal

MUST be changed at the same time.

Advertising
This manual is related to the following products: