Multiquip Cv1A - Manual (Page 11)

CV seRIes VIbRatoR motoR • opeRatIon and paRts manual — ReV. #0 (04/30/13) — page 11
safety inforMation
VIbRatoR motoR saFetY
dangeR
 alWaYs wear rubber insulated gloves and boots when
holding the fl exshaft during operation. The possibility of
electrocution exists causing equipment damage and
severe bodily harm even death!
dangeR
 If applicable, periodically check insulation resistance
as referenced in maintenance section. The possibility
of electrocution exists causing equipment damage and
severe bodily harm even death!
WaRnIng
 neVeR attempt to run the core outside the casing
assembly for any reason.
CautIon
 do not overreach. Keep proper footing and balance at
all times.
 do not carry plugged-in motor with fi nger on the switch.
 neVeR carry the motor by the cord. Use the carrying
handle.
 alWaYs check the vibrator motor for loosened hardware
such as nuts and bolts before starting.
 Keep the cord from heat, oil, and sharp objects.
 do not overload the motor. It will do a better and safer
job at the rate for which it was designed.
 do not expose vibrator motor to rain.
 do not use vibrator motor in damp or wet locations
without proper electrical circuits.
 alWaYs keep clear of rotating or moving parts while
operating the vibrator motor.
 neVeR leave the machine unattended while running..
 alWaYs disconnect the motor from the power source
when not in use, before servicing, and when changing
fl exible shafting and vibrator heads.
 Allow the vibrator motor to cool before
servicing. Contact with hot components can
cause serious burns.
 Before each use, alWaYs check the motor
to make certain that there are no damaged parts and that
all parts function properly (such as switch, cord housing).
If any damage or malfunctioning parts are found, have
them repaired or replaced by an authorized service facility.
NOTICE
 Secure forms. Make sure the form work is well made and
braced to withstand the stresses made by vibration.
 Keep vibrator motor clean for better and safer operation.
 alWaYs store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
 Use only factory-authorized replacement parts.
 Store idle vibrator motor. When not in use, motor should
be stored in a dry, safe storage area.
eleCtRICal saFetY
CautIon
 Prevent body contact with grounded surfaces such as
pipes, reinforcing bar, etc.
 When applicable, use a protection wiring device, such
as a Ground Fault Circuit Interrupter, for the protection
of personnel.
 Operate electric motor only at the specifi ed voltage
indicated on the nameplate.
 do not spray water onto electric motor.
 do not yank the cord to disconnect it from the
receptacle. Grasp the plug itself to disconnect it.
 alWaYs make sure the ON/OFF switch on the electric
motor is in the OFF position when not in use and before
inserting the power plug into an AC receptacle.