Noctua NC-U6 - Manual

Fixing the mounting brackets Congratulations on your purchase of the NC-U6 Chipset Cooler!
Please follow the instructions given in this manual in order to
install the
NC-U6 on your mainboard.
Box contents
Please choose the appropriate set of mounting brackets
according to the mounting system of your mainboard:
Caution: Do not overtighten the screw!
Mounting brackets
for push-pin holes
Mounting brackets
for hooks
Screw the mounting brackets to the heatsink using the
supplied screw:
Screw
Spacer
Foam
Applying thermal paste
If there are traces of thermal paste or thermal pads on your
chipset, please clean them off first. Spread a thin coating of
the supplied thermal paste on the chip.
Caution: Applying too much thermal paste will lower the
heat conductivity and cooling performance!
Should you have any questions, please consult the FAQ section on
www.noctua.at or contact us at [email protected].
Choosing the mounting brackets
NC-U6 Chipset Cooler
Installation Manual