NTi Audio Minirator MR-PRO - Manual (Page 44)

44
Troubleshooting
Faults and their correction
Fault Fault finding Cause Remedy
The Minirator does not gener-
ate an output signal. “Mute” button blinks. You have switched the
instrument to Mute. Press the “Mute” button.
“Mute” button lights up
continuously. You have called up the “Pink
Noise” (PNoise) test signal or
you are in the Pause cycle of
the Chirp test signal. Wait until the pause has
ended.
Press the “Start” button.
Non-supported Wave format. Load a supported Wav-format.
Cable not plugged in correct-
ly. Plug in the cable correctly.
Screen contrast poor. Contrast needs to be
adjusted. Press “ESC” and operate the
rotary switch to set the
contrast.
MR-PRO: Wave files are not
played back “Mute” button lights up
continuously. Non-supported Wave format. Load a supported Wave for-
mat.
MR-PRO indicates no
impedance. The lowest line is not
displayed. Output level too low.
Incorrect test signal. Increase the output level.
Change to the SINEWAVE
test signal.